RJ45 Injector POE Splitter Adapter Cable Kit Passive Power Over Ethernet 12-48V

This kit allows you to power non-PoE devices using passive PoE. The required DC voltage is injected onto Ethernet cable, and then split from the cable, at the device end, into a standard DC-jack.

This makes it possible to power a wide range of routers, switches, access points, and other devices over limited length cable runs

Sometimes it's hard to get power to your Ethernet devices. Wouldn't it be convenient to use the same cable for power and data? Using these power over Ethernet adapters, you can do just that! The complete Passive Power over Ethernet Kit contains two pieces - INJECTOR and SPLITTER. It is suitable for using with products that basically do not support Power Over Ethernet. Each cable has a female RJ45 on one side which is adapted to a male RJ45 and 5.5x2.1mm barrel jack connector on the other side. The 'injector' cable has a female barrel jack connector and the 'splitter' cable has a male barrel jack. MOBITRON-CAT-5-PASSIVE-POE-Power-Over-Ethernet-Injector-Splitter-Adapter Passive Power Over Ethernet SET is applicable for wide range of network products such as Access Points, Routers, IP cameras, modems, switches, embedded computers or other network devices. The devices can be supplied standard power up to 50V. (The power adapter is not included - it is possible to use the power adapter of the powered device as access point, IP camera etc.) Passive PoE`s range is normally form 30-40 metres/100-130 ft (the real distance depends on the power supply, type of cable and powered device). MOBITRON-CAT-5-PASSIVE-POE-Power-Over-Ethernet-Injector-Splitter-Adapter Simply attach the cables at each end of your network cable, plug the male barrel jack from the splitter into your target device and plug your desired power adapter into the injector. Now you can use one cable to provide both power and data for your Ethernet enabled device. Complete set for wide range of network products such as Access Points, Routers, IP cameras, modems, switches, embedded computers or other network devices such as D-Link, Ovislink, Senao, Wline, D-Link, TP-Link, Linksys, Airlive, Senao, Wline, Micronet, Edimax, RouterBOARD, WRAP boards and other devices using passive POE injection