12V / 24V PWM 30A Battery Solar Charge Controller

• Watch Video on how to use:  https://www.youtube.com/watch?v=S9-xOMrHTGg
• 1. Connect the positive and negative electrodes of the livestock battery into the controller according to the diagram, and the controller will automatically detect the voltage of the livestock battery.
• 2. Connect the positive and negative poles of the load into the controller according to the diagram, and be careful not to connect them in reverse
• 3. Connect the solar panel to the controller as shown in the figure.
• Note: please connect in strict accordance with the above order, otherwise the controller may be damaged,
• The disassembly sequence is opposite to the wiring sequence.
• Setting parameters
• In the interface 2-5, long press the up key for 5 seconds to restore the default value.
• Press and hold the menu key for 5 seconds to enter the manual setting. At this time, the number will flash,
• Press the up and down keys to adjust the parameter value, and then press the menu key for 5 seconds to exit the setting
•  

Note: 1. Main interface 1. Press the flip key alone to turn on / off the load.
          2. Interface 5 load working mode: [24h] load normally open mode