Focustar 500W 460.8WH Portabl Power Station Outdoor Mobile Power Emergency Power

Points for attention:

The portable power station device has high voltage AC output, which is potentially dangerous and must be handled with

care and kept away from children, otherwise there will be a risk of electric shock.

Do not connect the inverter of the portable power station to the AC circuit, otherwise even if the switch of the device is

turned off, the inverter of the device may be damaged.

Please ensure that the power used by the electrical appliance is less than the rated output power of the portable power

station device.

Before the load is connected to the portable power station device, be sure to turn off the load switch before connecting it,

and then turn on the load switch for use.

It is recommended to charge the portable power station device for at least 10 hours before use. Insert the AC adapter

charger into the portable power station’s charging port when charging. The portable power station device can also be

used without charging, but the backup time will be less than the standard backup time.

It is prohibited to connect half wave (hair dryer, electric heating wire heater) load, high-power motor, laser printer,

high-power rectifier load. The portable power station will be automatically protected because of the excessive starting

power during operation.

Description of protection functions and application scenarios:

1. Protection functions: over voltage protection, over current protection, over temperature protection, overcharge

protection, short circuit protection, under voltage protection.

2. Application scenarios: home emergency power supply, outdoor camping power supply, night construction power

supply, emergency rescue power supply, etc.

Use load type:

1. AC fans, DC fans, AC LED lights, DC LED lights, digital products, mobile phones, desktop computers, notebook

computers, TVs, vacuum cleaners, etc.

Operation method:

Power on:

1. When there is no charging, press the power switch on the panel for more than 3 seconds, release it after the

LCD display lights up, and then press the corresponding function switch at this time, there will be a

corresponding output. If the corresponding function switch is not pressed within 10 seconds, the portable

power station will enter the automatic shutdown state.

2. If there is solar energy and DC charger are connected, the LCD screen will automatically light up.

At this time, press the corresponding function switch, and there will be a corresponding output.

Power off:

1. When there is no charging, press and hold the power switch on the panel for more than 3 seconds,

release it after the LCD screen goes out, and then shut the portable power station down.

2. If the solar energy and DC charger are connected, the LCD cannot be turned off, so turn off the

corresponding function switches and turn off each output.

3. When there is no charging and no output switches are turned on, it will automatically shut down after 10

seconds.

Note: The portable power station has DC under voltage and over voltage protection functions. When the

battery is under voltage or over voltage, it will automatically shut down.