Operational Amplifier Op Amp Tester Single Op Amp Dual Op Am

Detailed Information About The Product:

Common single-op-amp and dual-op-amp Screening circuit boards finished boards the circuit board can judge whether the IC can be used for amplification and can roughly judge the conversion rate of the chip.
IC1a in the circuit is connected to a multivibrator with a frequency of about 1Hz and the OP Amp. to be tested is connected to a unity gain inverting amplifier working state. IC2 is an EX-OR gate and its truth table is that the output is 1 when the two inputs are inverted. The original design D3 is green because the solder mask of the printed board is green and not eye-catching so it is changed to a yellow LED.
For chips with a low conversion rate the status indicated by the LED is steady yellow and red will flicker faintly. This can also be used to roughly judge the conversion rate of the chip. Because most of the motorcycle chips on the market use low conversion rate instead of high rate it can also be judged whether the chip is counterfeit or not.

Therefore after pow er-on there are the following situations:
If OP Amp. is normal points A and B of IC2 must be reversed so C is 1 and it is still 1 after IC1b and 1d so D3 of the yellow LED lights up and the red LED goes out
If the OP Amp. output is open the C point of IC2 must always be 0 and it will become 1 after IC1c so that the yellow LED is extinguished and the red LED D4 is lit.
If the internal short circuit of OP Amp. makes the output voltage fixed to positive or negative the output of IC1c is also a 1Hz low-frequency square wave and the red and yellow LEDs will flash alternately.
The actual test of low conversion rate such as: OP07 LM741 yellow is always on red is slightly bright.
Test chips with high conversion rates such as TL071 NE5534 MC34071 and other chips the yellow is always on and the red is off.
Single op amp model: LM741 LF356 NE5534 TL071 TL081 OP07 and other standard package single op amp.
Dual op amp model: LM358 NE5532 TL072 TL082 MC1458 RC4558 OP275 AD827 and other standard package dual op amps.
PCB size: 9.2 x 5.8 cm
pow er supply requirements: Voltage: 12VDC current above 100mA.
Colour: black
Material: plastic

Package Contents:
1 x Operational amplifier

Only the above package content other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
About Us
We provide the good product with the best pricewe support Wholesale/Drop Shipping Order
1. For Drop Shipping order please remark"dropshipping order" we will prioritize it.
2. For Wholesale/Drop Shipping orders if you have any ideas about the price or packageplease contact us in advancewe will give you the best service to satisfy your demands.
About Shipments
1.We will send out the orders ASAP once your payment is completed normally.
2.Please write your complete delivery address with correct phone number and zip code especially please confirm your full name.
About After-sale Service
We are reliable seller and we have our professional after-sale service for all of our customers. If there is any question about the orderplease contact us in advance we will always here until you get a happy answer.
About Feedback
1. Please check the package and item when you get carefully to make sure there is no problem.
2. If you have any problem or are not entirely satisfied with your packageplease don’t be hesitate to contact us first before leaving negative feedback. We will resolve the problem to satisfy you.
3. If there is no problem please leave us five star positive feedback.
Your affirmation is our greatest motivation ! ! !