Multi Taper Superior Taper Professional Cord Hair Clipper

A good quality pair of hair clippers will not only save you a lot of money and time, they will also last you many years if you look after them properly.If your clippers are in frequent use, you really need to ensure they are in good working order.Some basic care and maintenance every now and again will keep your clippers performing to their best.Keep The Blades CleanBefore you begin to cut your own or anyone else’s hair, make sure the blade area is clean, and any hair and debris are removed.Most clipper sets come with their own small clipper brush and cleaning kit.I find these brushes too small and flimsy.I prefer to use an old, hard toothbrush to really get in among the ‘nooks and crannies’ You can also use a wire brush, a cheap fingernail brush or hair tint brush, as long as they are quite sturdy.Amazon sell a decent clipper cleaning brush if you haven’t got anything suitable.Brush away all the hair clippings and debris from the blade areThese small deposits can act like grit or sand if they get between the blades and blade teeth.If unchecked they could eventually cause the blades damage and blunt them.Brush everything away. Blowing sharply into the area will also help.Ensure The Blade is Aligned CorrectlyThis step is particularly important if you intend to cut other people’s hair or are using your clippers in a barbers or hair salon.Every time you come to use the clipper, hold it sideways down its length.The blades should be either parallel with the cutter blade or set slightly back.There shouldn’t be any teeth protruding and the blade should be perfectly straight. A crooked blade or a stray tooth could easily nic or cut you, or a client.There’s no need to take them out, just loosen them so there’s enough ‘give’ to wiggle the blade back into place.Be careful when tightening the screws again or you might offset the cutting blade.Alternate between each screw to ensure the blade doesn’t twist and become crooked.When all the screws are tightened, visually check again to ensure the blade is even and correctly aligned.Turn on the clipper and lightly run the blade over your finger or hand to ensure its aligned correctly.