Width 10mm & Length 3M

Description:
100% 3M Brand New.
With Strong adhesion for automotive substrates.
Weather and car wash resistant.
High-strength core maintains a thin, consistent bond line.
Great for the attachment of a wide range of automotive exterior and interior trim including body side moldings,wheel flares, rock panel trim,bumper trim, claddings, and most automotive trim.
Also can be use on LED strip mounting at indoor or outdoor.
Material: Foam
Length: 3m
Width: 5/8/10/12/15/20/30/40mm
The width can be customized, contact .
Package Included:
1 PCS Double Sided Tape
Application Guidelines :
50% strength of bond in 20 minutes, 90% strength of bond in 24 hours,and 100% strength of bond after 72 hours.
Note:Clean the work surface, make sure it's smooth and clean. Please
and let sit for 24 hours, the longer the more viscous.
How to use this tape?
Clean: For maximum bond strength,the surface must be clean, dry, smooth, have no rust and pollution.Typical cleaning solvents are heptane or isopropyl .
Pressure: Pressure on the adhesive and the surface can help improve bond strength, roller or platen can be used.
Time: After application, the bond strength will increase as the adhesive flows onto the surface. At room temperature approximately 50% of ultimate bond strength will be achieved after 20 minutes, 90% after 24 hoursand 100% after 72 hours.
Temperature:Ideal application temperature range is 70°F to 100°F (21degree centigrade to 38degree centigrade).Operating temperature should not be below 10 degree centigrade, the temperature is too low, will lead to cure time longer. If temperature is too low, material and adhesive tape into the warm indoor storage or heating .