SJ JX Arcade Game USB Boardro Command Zero Delay on Controller for Nintendo Switch PC PS3

Include:

1xro Board,

1x USB Cable,

Multe cables for ons and s.

1. Pre and hold the ro on until the ro LED fes to start editing the ro command.

2. Enter the key combination sequentially.

(1) Available ons: A, B, X, Y, L1, L2, L3, R1, R2, R3, SE, ST.

(2) Available s: up, up-left, left, down-left, down, down-right, right, up-right.

(3) The key value is output at a fixed rate, and the time interval for inputting the key value is not recorded.

3. Short pre the ro on, the LED stops fing, and the is succeful.

4. Pre the ro on to sequentially output the recorded key combination.

5. For example:

(1)Pre and hold the ro 1 on until the light fes.

(2)Pre in sequence: left, down-left, down, A, B.

(3)Short pre the ro 1 on, the indicator light stops fing.

(4)Then, short pre the ro 1 on, the en board will output left, down-left, down, A, B in sequence.

6. SOCD (Simultaneous Opposing Cardinal Directions): 

Preset 5 different SOCD modes.

Select the mode you want, hold down the X, A, B and Y on, then pre the select on once. 

The LED blinks a few times and then turns off, and the setting is succeful.

(1) on X + Select:

←+→=→, ↓+↑=↑, ←+↓+→=↓.

(2) on A + Select (default. Applies to most situations.):

←+→=None, ↓+↑=None, ←+↓+→=↓.

(3) on B + Select:

←+→=→, ↓+↑=↑, ←+↓+→=↘.

(4) on Y + Select:

←+→=None, ↓+↑=↑, ←+↓+→=↓.

(5) on L1 + Select:

←+→=←, ↓+↑=↑, ←+↓+→=↓.

7. Separate D-pad/X-input switch ons are compatible with all older games. Pre and hold the on for 5 seconds, The will switch to the working mode, PC/PS3, Xbox 360 for Windows.

8. Pre A+Turbo/Clear at the same time to set multe clicks of the A on. Simplified operation. Pre A+Turbo/Clear again to cancel.

9. e sure to open Pro Controller Wired Communication on the Nintendo switch settings page when it work on Nintendo Switch

10. The can be upgraded on the computer through the USB interface.