Mini DC Geared Motor 6V 12V 24V High Speed 23 To 1930RPM In DC Motor With Mounting Bracket Coupling Toy Car Wheels

Introduction of the motor

1. Name of the motor : electric micro dc gear motor in dc motor( Contain mounting bracket ; coupling and wheel)2. Rated voltage : DC 24V3. DC 24V ; You can choose the no load speed have :17rpm/39rpm/50rpm/85rpm/110rpm/190rpm/250rpm/400rpm/915rpm/1930rpmRated torque between 0.5 to 8 KG.CM; stall torque: between 1 to 9KG.CM, it is recommended that your project load not exceed the rated torque; Select a no load speed in DC 24V, there will be corresponding rated torque and stall torque, please refer to the table below.4. Direction of rotation of the motor: CW Or CCW, Support Red;Control the clockwise or counterclockwise rotation of the motor by changing the way the positive and negative electrodes are connected5. The shaft shape of the motor : D type, please refer to the size chart below for all dimensions of the motor.6. Gear material: Metaears e the motor last longer7. The speed of the motor can be adjusted using the speed controller.8. The motor has standard noise when working. If your project has requirements for the working noise of the motor, please consult us before purchasing. We wilive you some suestions. Thank you.When the motor is red, the working sound of the motor will be greater than the forward rotation, which is normal.9. This motor is suitable for a variety of micro-automation equipment. As as you confirm that the motor voltage and torque of your choice are suitable for the voltage and load of your project before purchase, there is no limit to the scope of use of this motor.For example, ; DIY toy car etc.10. Pa: 1 piece of the gear motor ; 1 piece of the mounting bracket ; 1 piece of the coupling ; 1 piece of the wheel (Includes mounting screws)

Hall introduction

1. Outer diameter size: 25mm2. Number of Halls: 2 Hall elements have a two-phase AB output, Hall is a unipolar Hall3. ic ring material: diameter 14mm; thickne 5.5mm; inner hole suitable for mounting motor shaft diameter 2mm4. Hall voltage: 5V/3.3V5. Line speed : Basic number 11PPR ; The motor rotates one turn and outputs 11 s.6. Basic functions: It has a pull-up shaping , and the MCU can be directly connected.7. Interface Type : PH 2.08. Output signal type : Square wave AB phase9. Response frequency : 100KHz10. The number of ic ring trier stages is 22 (11 pairs)11. Gearbox resolution of the motor = 11 s * reduction ratio

Line Wiring Method

1. Red line : DC power supply positive pole connected to the motor(Control the clockwise or counterclockwise rotation of the motor by changing the way the positive and negative electrodes are connected2. Blawire : The negative power supply required to connect the 3.3V / 5V(Note: the positive and negative poles cannot be connected incorrectly)3. Yellow wire : signal feedbaline; The motor rotates one turn and outputs 11 signals.4. Green line : signal feedbaline; The motor rotates one turn and outputs 11 signals.5. Blue line : The positive power supply required to connect the 3.3V / 5V(Note: the positive and negative poles cannot be connected incorrectly)6. White wire : Connect the negative DC power supply of the motor(Control the clockwise or counterclockwise rotation of the motor by changing the way the positive and negative electrodes are connected)

Sincere reminder

Your project load should not exceed rated torque of the motor, otherwise the life of the motor will be reducedThe s in the table below are the s for the motor connection rated voltage 24VIf the motor is connected to a non-rated voltage input, all s of the motor will change.