For BMW EWS ImmO Auto EWS2 EWS3.2 Emulator

₦ 16,200

₦ 28,33443%

1 units left

+ shipping from ₦ 3,785 to LEKKI-AJAH (SANGOTEDO)

0 out of 5

(No ratings available)

Promotions

Call 07006000000 To Place Your Order Need extra money? Loan up to N500,000 on the JumiaPay Android app. Enjoy cheaper shipping fees when you select a PickUp Station at checkout.

Report incorrect product information

Delivery & Returns

Shipped from abroad

Choose your location

Pickup Station

Delivery Fees ₦ 3,785

Ready for pickup between 23 June and 25 June if you place your order within the next 10hrs 36mins

Door Delivery

Delivery Fees ₦ 4,545

Ready for delivery between 23 June and 25 June if you place your order within the next 10hrs 36mins

Return Policy

Free return within 7 days for ALL eligible itemsDetails

Warranty

None

Seller Information

Williame

88%Seller Score

5 Followers

Seller Performance

Shipping speed: Good

Quality Score: Excellent

Customer Rating: Good

Product details

Detailed Information About The Product:

Top 2 Reasons To Get BMW EWS2 EWS3.2 Emulator
There are NO any counters or car starts limited. You can change and store new ISN without any limitations.
Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN 0579 is stored by default.
Notice: In case of EWS3.2 similar procedure is used, only difference is that that it is NOT connected directly to diagnostic K-line.

Installation:
1. Remove EWS2 control unit, find +12v ACC, GND, K-line wires, attach emulator. Emulator must be in service mode: JUMPER 1 shorted.
2. Connect ANY K-line diagnostic adapter to vehicle diagnostic connector and launch EMULATOR CONFIGURATION UTILITY:
3. Choose COM port, write in desired ISN number, press button Store. Or -
4. For some ECU s it is possible to read ISN number directly from engine control unit. In this case select option ECU xxxxx , press Read. Software will try to read ISN. If successful, choose option EWS emulator and press button Store to save ISN number into emulator.
5. Disconnect emulator from K-line, remove JUMPER 1 and connect K output from emulator to DME(DDE) -EWS line.
6. Don t forget to short two starter relay wires (EWS connector)!
7. Car is ready to start.
Colour:green
Material:Electronic component

Package Contents:
1 x Emulator(without wire)

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.