Engraver Shield R3 Board A4988 Motor Drivers For Arduino Engraver

Engraver Shield Board +Arduino R3 Board + 4 x A4988 Motor Driver

(1)Engraver Shield Board
Version:3.0
:Red
Size(L*W*H):68 x 53 x 18 mm
Voltage: 12~36 V (At the moment the DR825 drivers can handle up to 36V so please consider the operation voltage when powering the board.)

Features:
1.Uses removable A4988 or DR825 compatible drivers.
2.The extension board can be used for carving hine, 3 d printer driver expansion board
3.GRBL 0.8 compatible. (Open source that runs on an Arduino UNO that turns G- commands into signals)
4.PWM ndle and direction pins,4-Axis (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom using pins D12 and D13)
5.Compact design. Motors can be connected with 4 pin molex connectors or soldered in place.
6.Please note that this is an unembled kit and Basic skills are needed.

(2)A4988 Motor Driver
:Red
Size(L*W*H):20 x 15 x 10 mm
Thermal shutdown circuitry:Yes
Crossover-current protection:Yes
Ground fault protection:Yes
Load short-circuit protection:Yes
Compatible logic suly: 3.3V and 5 V
Five selectable step modes: full, 1/2, 1/4, 1/8 and 1/16

Features:
1.Mix with slow current decay modes.
2.Internal UVLO and Low RDS (On) Output.
3.Automatic current decay mode /selection.
4.Synchronous rectification for low power dissation.
5.Warning: Connecting or disconnecting a motor while the driver is powered can destroy the driver.

(3)Arduino R3 Board
MCU: ATmega328
Clo speed: 16 MHz
USB inteace: ATmega16U2
Operating voltage: 5 V
I-I/O pin output current: 40 mA
3.3 V output current: 150 mA
ital I/O pins: 14 (including 6 with PWM capability)
Analog input pins: 6
EEPROM: 1 kB
Sc RAM (SRAM): 2 kB
Flash ory: 32 kB
Size(L*W*H):68 x 53 x 10 mm

Paage Included:
1 x Arduino R3 Board
1 x Engraver Shield Board
4 x A4988 Motor Driver
1 x 40-Pin Row s
1 x Cable

Note:
Manual measuring, please allow 1 ~ 3 cm error,thank you.