Digital Display Surge Protector

STONE-TECH Digital Display Surge Protector 13A

This guard is an under voltage with over voltage protecting device rated at13Amps. The guard will disconnect if the mains supply goes below a pre-set limit and re-connect automatically only after the supply has returned to acceptable limits for the duration of the wait time (delay mechanism)

All electrical and electronic equipment connected to the mains supply is at risk of being damaged from spikes, surges, lightening, brown- outs, power cut (blackout),power back surges and over-voltage.

Without doubt, power interruptions causes major problems for homes and businesses. An unpredictable power supply from NEPA or Generator can lead to very damaging situations such as surges, spikes, brown outs, and abrupt utility failure. If any of this should occur, there is a very likely chance that you could lose data from your PC of your compressor in you Fridge or Freezer may go bad. This occurrences my even lead to your losing your very expensive equipment.

This product encompasses a wide range of power protection products for use in many different industries where clean, regulated mains power is critical to their continued operation.

• Adjustable Delay wait time set on 5secs or 3minutes.
• Working, Waiting, High and Low voltage indicators
• Over voltage, under voltage and Surge Protection
• Protects, Fridge, Freezers, & General Electronics
• Noise Filtering
• Voltage pre-set at 140v to 275v
  
• Current Rating 13Amps
• Max. Power 3000watts
• Frequency 50/60Hz auto sensing
• Mains Spike response time Less 10ns
• Spike protection 160
• Mains spike discharge Amps 6.5KA
•