DC 12V 10A 2CH Relay Multifunctional Module

DC 12V 10A 2CH Relay multifunctional Module Receiver EV1527 Wireless Remote Control 433 Mhz Remote Switch for DC Motor DIY

• I am an international seller

Our shop sells the most popular 3C consumer electronics products,such as mobile phone accessories,computer accessories,game peripherals,smart wearables,and follow the most popular fashion trends. If you like our products,please follow us,become our follower and fan.We will provide you with the most popular products to satisfy your fashion shopping experience.DC 12V 10A 2CH Relay multifunctional Module Receiver EV1527 Wireless Remote Control 433 Mhz Remote Switch for DC Motor DIY

1. Working Voltage: DC 12V-36V
2. Working Frequency: 433Mhz
3. Receiving sensitivity: -105dBM
4. Max Load: 10A Relay ( have better load less than 5A)
5. PCB Size:75*58*15mm Case Size :95*62*29mm
6. Function: Limit & Wire External on
7. State OFF, (Suddenly, the electricity was cut off, then comes again, the State still is OFF, you need manual turn it ON)
8. Out State: Momentary Latched Adjusted by the Jumper on the Receiver,
( we ship default as Latched, if you need use Momentary to change the Jumper on the Receiver ,)

9. Working way changed by jumper on pins

Momentary: jumper doesn't connect any two pins.
Relay: Press and hold -> On; Release -> Off.

Toggle: jumper connects the pin T and pin S.
Relay: Press -> On; Press same on again -> Off·

Latched: jumper connects the pin L and pin S.
Relay: Press -> On; Press other on -> Off.
12. When the relay is activated, the buzzer synchronize with a “beep” prompt.
13. When the receiver output state is “Latched”, we have set it 0.5s time delay for forwards and reverse, it is the Protection function.
14. We have made transmitter and receiver working together and test it before ship it,when you get it don't need to do anything ,just install it.
15. Learning e :
(1) Press the learning on for 1 time,the learning indicator flashes slowly,Then press the transmitter on up (first on default for forward) ,the learning indicator flash 5 times and OFF,It mean the first on learning Successfully

(2) Press the learning on for 2 times,the learning indicator flashes slowly,Then press the transmitter on down (second on default for forward) ,the learning indicator flash 5 times and OFF,It mean the second on learning Successfully

(Third on default for stop ,When the jumper set for Latched)
16. Clear e :
Press the learning on on the receiver for 5s,the learning indicator will flash 3 times and OFF , It mean all the transmitter e in the receiver have been cleared.