Car TPMS Reset Tool EL50448 Auto Tire Pressure Monitoring System Relearn Tool For GMC/Opel/Buick/Chevrolet/Cadillac/Saturn/Saab

EL50448 TPMS Relearn Tool For GM/Opel/Buick/Chevrolet

Tips for using

1. 9V Battery shold be in good condition: New & fully charged. (Battery not included)

2. e sure fits in CORRECT position.

3. Do tire reset outside instead of in the garage.

4. Position of tires are also ant, front tires have to be sight.

5. should be / OEM which are already well programmed.

6. Be sure all other are out of range of vehicle (10 ft range min).

7. Disable all other WIFI/Bluetooth and electronic acceory devices. Includs HID kits, car audio syst, navigation, back-up cameras, if NOT equipment, these devices may cause RF disruption.

Why need this EL50448 TPMS Relearn Tool?

The tire preure light is on Exchange the ECU Change the r Rotate Tires The r lose signal

EL50448 TPMS Relearn Tool Will Help You.

For GM vehicles equipped with a 315 or 433 MHz Tire Preure Monitoring (TPM) system, a "r Re-Learn Procedure" must be performed after tire rotations, e Control Door LoReceiver Module repment or Tire Preure r repment. This re-learn procedure can be performed by using special tool EL-50448.Also works on 2014 GM models

EL50448 TPMS Relearn Tool Details:

EL50448 works on most General Motors (for Buick, for Cadillac, for Chevrolet, for GMC) products manufactured for the North American market. It won't work if you've purchased aftermarket that are the wrong frequency. The tire preure r on models in & after 2012 can be read, only with some specified tools. Before tire preure monitoring system works normally properly, the body control module will record ID information of each position in the tire preure r; and use the following methods to read the tire preure r after replacing a tire or wheel speed r.

How to use EL50448 TPMS Relearn Tool

Step 1 - Enter leaning mode Set the gearshift lever to "P" Put the ignition switch to "ON" Enter the interface of tire preure display by DIC DIC shows "Pre Set / Ctrl to re-learn" Pre "Set / Ctrl" The turn signal is lighted for 3 seconds and the horn beep sound twice to enter the learning mode.

Step 2 - Read tire preure r information Start from the front-left wheel, e the J-46079 or Tool EL-50448 up against the valve core position & close to the rim of the tire sidewall El-50448 tire preure tool starts by the start switch Succeful to read the tire preure r information when the horn bleeps once.

Step 3 - Same method to read other tire preure information Follow the instuction above to read tire puure of the front-right, rear-right, rear-left wheels. Turn signals is lighted for 3 seconds and the horn bleeps twice when the learning is complete. For certain vehicles equipped with a Tire Preure Monitoring (TPM) system, a "r Re-Learn Procedure" must be performed after tire rotations, e Control Door LoReceiver Module repment or Tire Preure r repment. This re-learn procedure can be performed by using special tool 50448.

Packing List

1pc * EL50448 TPMS Relearn Tool

1pc * English User Manual

EL50448 Support Vehicle List: