Car Rca Sensor Blind Spot Detector Microwave Aoa Driving istance Reversing Safety Iconic Signal Light Led Warning

Features:

production functionexplanationfirst-cla alarm:prompt light flashing+buzzer prompt sound1.BSD blind zone warning( area:4meters horizontally and 10 meters vertically working logic：）start BSD warning mode when the vehicle speed is >18km/hA.when the target with speed>10km/h enters the area (the vehicle does not turn on the area(the vehicle does not rurn on the turn signal),the first-cla alarm will be generated until the target leaves the area and teh alarm will be cancelled.B.when the target with speed >10km/h enters the area (turn on the turn signal),a secondary alarm will be generated until the target leaves the area, and the alarm will be cancelled.2. LCA vehicles approach the early warning area:A.when the vehicle speed is 0:4m horizontally and 15m longitudinally.B.when the vehicle speed is 18-60km/h:4 meters horizontally and 15-20 meters longitudinally, increasing or decreasing with the speed.C.when the vehicle speed is more than 60km/h:4m in the horizontal direction and 20-30m in the vertical direction,increasing or decreasing with the speed.3.AOA overtaking warning ( area：4m in horizontal direction and 10m in vertical direction) working logic:start AOA overtaking warning mode whe the vehicle speed >18km/h.A.when the vehicle actively overtakes other targets with speed>10km/h and is in the area, it will generate a first- cla alarm until the target leaves the area and cancel the alarm.B.when the vehicle actively surpaes other targets with speed>10km/h and turns on the rurn signal on the cprres[pmdomg sode om the alarm range, a secondary alarm will be generated until the target leaves the area, and the alarm will be cancelled.4.working logic of RCT reversing warning ( area:5-15m sector area):start RCT reversing warning mode when R(reverse gear)is engaged:when the target enters the area, a secondary alarm is generated until the target leaves the area, and the alarm is cancelled.

Easy to installation:

installation methodinstallation of millimeter wave radartwo radar heads are installed in the bumper at the left and right corners of the rear end of the car body.specific installation steps are as follows:bracket installation:the bracket is installed in the bumper,and the appropriate position is selected. the height is best near the middle line of the car height,but it must be ensured that there is enough space for installing the radar, and the radar is not blocked by any metal(such as lampshade,anti-collision beam,etc.)after.the bumper is covered; the position of the bracket should not be too close to the upper and lower edges of the space,and the distance from the upper edge should be more than30mm;the bracket can't sink too deep into the space cavity either. it's better to make the depth from the radar surface to the cavity opening le than 10mm, as shown in the following figure. special attention:after the bumper is covered, the radar can not be blocked by the reversing radar on the buper, and the distance between teh two is better than 30mm.adjust the angle of the bracket so that the angle between the normal direction of the radar mounting mounting surface on the bracket and the longitudinal direction of the vehicle body is 35 degrees. the installation ruler can be used to ensure the correct installation angle. see the following figure for the use of the installation ruler.fixed mode of radarwhen fixing the radar head, ensure that the connecting line of the radar head faces the outside of the vehicle,and the back of the radar head clings to the bracket. fix the radar head on the bracket with screws to keep the radar head vertical