5PCS//LOT Arduino Uno R3 Rev. 3 A000066 ATmega328P MCU 16MHz Development Boa

Arduino Uno Rev. 3 Microcontroller Board is based on the Microchip Technology ATmega328 8-bit Microcontroller (MCU). Arduino Uno features 14 digital input/output pins (six of which can be used as PWM outputs), six analog inputs, and a 16MHz quartz crystal. Uno also includes a USB connection, an In-Circuit Serial Programming (ICSP) header, and a reset button. This Arduino MCU board contains everything the user needs to support the MCU. The user can get started by connecting the Uno to a computer with the USB cable or by powering it with an AC/DC adapter or battery. The Uno can be programmed with Arduino Software (Integrated Development Environment). The ATmega328 on the Uno comes preprogrammed with a bootloader that allows the user to upload code to the MCU without using an external hardware programmer. 

Arduino Uno differs from preceding boards in that it does not use the FTDI USB-to-serial driver chip. This board instead features the Atmega16U2 programmed as a USB-to-serial converter.

Features

Microchip Technology ATmega328 8-Bit AVR Microcontroller

5V operating voltage

6V to 20V input voltage (limit)

14 (with 6 providing PWM output) digital I/O pins

Six analog input pins

20mA DC current per I/O pin

50mA DC current for 3.3V pin

32KB Flash memory (ATmega328P), 0.5KB used by bootloader

2KB SRAM (ATmega328P)

1KB EEPROM (ATmega328P)

16MHz clock speed

68.6mm x 53.4mm (LxW)

25g weight

Powered via a USB connection or with an external power supply, the power source is selected automatically

Includes a number of facilities for communicating with a computer, another Uno board, or other MCUs, ATmega328 provides UART TTL (5V) serial communication, available on digital pins 0 (RX) and 1 (TX)

ATmega16U2 on board channels this serial communication over USB and appears as a virtual com port to software on the computer

16U2 firmware uses standard USB COM drivers

No external driver needed