3Pcs SHT31-D Temperature Humidity Sensor Digital Output Se

₦ 12,863

₦ 25,48350%

1 units left

+ shipping from ₦ 3,201 to LEKKI-AJAH (SANGOTEDO)

0 out of 5

(No ratings available)

Promotions

Call 07006000000 To Place Your Order Need extra money? Loan up to N500,000 on the JumiaPay Android app. Enjoy cheaper shipping fees when you select a PickUp Station at checkout.

Report incorrect product information

Delivery & Returns

Shipped from abroad

Choose your location

Pickup Station

Delivery Fees ₦ 3,201

Ready for pickup between 27 June and 01 July if you place your order within the next 23hrs 51mins

Door Delivery

Delivery Fees ₦ 3,961

Ready for delivery between 27 June and 01 July if you place your order within the next 23hrs 51mins

Return Policy

Free return within 7 days for ALL eligible itemsDetails

Warranty

None

Seller Information

kristinap

90%Seller Score

103 Followers

Seller Performance

Shipping speed: Good

Quality Score: Excellent

Customer Rating: Good

Product details

The product information is as follows:

Name:3Pcs SHT31-D Temperature Humidity Sensor Digital Output Sensor Module IIC I2C Interface 3.3V for Arduino Raspberry Pi
Supply voltage range: 2.4 to 5.5V (typically 3.3V)
RH working range: 0-99.99%RH ; I2C interface, communication rate up to 1MHz, with two user-selectable addresses
Operating temperature range: -40 to 125Celsius (-40 to 257Fahrenheit)
RH response time: 8 seconds (tau63%)
Typical accuracy is +/- 2% RH and +/- 0.3 inch with high accuracy

Sensor Manufacturer: #SHT31-DIS
RH response time: 0-100% RH
Interface: I2C
Power Pins:
Vin - this is the power pin. The chip can use 2.5-5VDC for power. To power the board, give it the same power as the logic level of your microcontroller - e.g. for a 5V Mini like for Arduino, use 5V. For a 3.3V controller like a Raspbery Pi, connect to 3.3V GND - common ground for power and logic
SCL - I2C clock pin, connect to your microcontrollers I2C clock line. This pin has a 10K pullup resistor to Vin
SDA - I2C data pin, connect to your microcontrollers I2C data line. This pin has a 10K pullup resistor to Vin
ADR - This is the I2C address selection pin. This pin has a 10K pull down resistor to make the default I2C address 0x44. You can tie this pin to Vin to make the address 0x45
RST - Hardware reset pint. Has a 10K pullup on it to make the chip active by default. Connect to ground to do a hardware reset!
ALR - Alert/Interrupt output. You can set up the sensor to alert you when an event has occured. Check the datasheet for how you can set up the alerts
Colour:Photo Color
Material:plastic

Package Contents:
3 x SHT31-D Temperature Humidity Sensor

Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.