3.2 Inch Tft Lcd Display + Tft/Sd Shield For Arduino Mega

Detailed Information About The Product:

Name：3.2 inch Tft Lcd Display + Tft/Sd Shield For Arduino Mega 2560 Lcd Module Sd Level Translation 2.8 3.2 Due
you can drive TFT LCD in a much faster speed using 84Mhz Ardiuno DUE. The shield is designed to fit two types of LCD:
1. 40pin version LCD which is commonly used in previous version of TFT Mega shield for Arduino MEGA 2560
2. 32pin version LCD which is commonly used in STM32 development board. (unsoldered)
The shield route all the LCD data pins to port PC1-PC8 and PC12-19, control pins to PD0-PD3, this design can acheive high speed data transfer (three cycles per write strobe to the LCD) to maximize LCD display speed. The SPI interface (for SD or flash control) is route to the ISP header of arduino DUE, so that high speed SPI transfer with DMA can be achieved.
The shield is compatible with Arduino DUE and the following LCD
Colour: Black
material: metal
Overview:
3.2 inch TFT LCD Display is a LCD Press screen module. It has 40pins interface and SD card and Flash reader design. It is a powerful and multifunctional module for your project. The Screen include a controller SSD1289, it's a support 8/16bit data interface , easy to drive by many MCU like STM32 ,AVR and 8051. It is designed with a Press controller in it . The Press IC is ADS7843 , and Press interface is included in the 40 pins breakout. It is the version of product only with Press screen and Press controller.
Specification:
240374PQ
65K color
320*240
3.2 inch
Wide viewing angle
SSD1289:240 RGB x 320 TFT Driver
Integrated Power, Gate and Source Driver With RAM
ADS7843:4-WIRE TOUCH, UP TO 125kHz CONVERSION RATE, SERIAL INTERFACE
Package Contents:
1* display
1* DUE module
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.