2 Axis USB CNC Stepper Motor Control Board Driver 12V Power For Laser Engraver

Specifications:
Brand EleskMaker Model ManaSE Interface USB Size 94*46mm Hole Size 85x36mm Support Axis XY聽axis Power Requirement Higher than12V 2A Support Stepper Motor Motor within 2A 2-phase 4-wire Input Voltage 12V Power Interface DC5.5 - 2.1 聽(Inside is positive 聽electrodes聽and
ouside is negative electrodes) 聽
Features:
1. Fit for DIY desktop laser engraver,dispensing machines printer,plotter
2. Come with USB cable and connector wires.
3. 2-axis聽聽linkage Y-axis dual interface, can drive a stepper motor within 2A 2-phase 4-wire.
4. Large MOS tube,onboard DC buck module, jumper 聽ADJ can adjust manually the laser voltage to control the laser power

Tips:
EleksCAM software download link is here :聽Click here

Note:
There isn't 聽Voltage Regulator Module in this 聽Laser board .
The motor can not 聽work hight 聽than 2A,聽when the motor work for a long time聽in 1A to 2A , please pay attention to heat

The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.

Please allow slight deviation for the measurement data.

Please allow 0.1-0.5cm error due to the hand measurement.

聽

If聽you聽have聽any聽questions,聽please聽contact聽us.

Wish聽you聽have聽a聽happy聽shopping聽time!