12V Singe One Way Wireless Remote Control Switch Contro

Features:

The wireless remote control switch adopts Radio Frequency Identification technology, which is mainly used for remote wireless home appliance control.

Selectable working modes - Jog / Self-locking / Interlock.

It can control one or more devices in the room, and the performance is stable and reliable.

Easy to use.

Remote control distance: 100 meters in open area.



Specification:

Type: 12V Wireless Remote control switch single controller

Weight: about 57g (controller + remote control)

Size: about 3.9x3.6x2.5cm

Type: Single One-way remote control switch

Working voltage: 12V

Working frequency: 433MHZ

Total load power: 10A

Remote control distance: 100M

Working temperature: -15-75℃

 

Package list:

1 * Remote Control

1 * Switch



Note:

1. Please allow slight error due to manual measurement.

2. Different monitor colors may be different. Thanks for your kind understanding.



Output Mode:

1. Self-locking: Press the same remote control button, press once, the relay is on, press again, the relay is off.

2. Interlock: Press the "A" button on the remote control, the relay will open, press the "B" button on the remote control, and the relay will be off.

3. Jog: Press the "A" button on the remote control, the relay will open, release the "A" button on the remote control, and the relay will be off. If you keep pressing the "A" button, the remote control is always on. When will it be released then when the relay is off.



Remote Control:

1. Clear code: Press and hold the learning button, the indicator light is on. After about 8 seconds, the indicator light flashes 3 times and then off, indicating that the clearing is successful. The remote controllers that were paired before being erased are all deleted.

2. Working mode selection: The switching mode of this switch is changed by using the jumper cap. The jumper cap is not inserted into the jog mode, inserted in the middle of the T is self-locking, inserted in the L and the middle is interlocked.

3. Learn to match the remote control: Press the learning button, the indicator light is on, then press the remote control button to be matched, the indicator light flashes 3 times and then the corresponding remote control is successfully paired.

If there's multiple remote controls, just repeat step 3 without clearing the code.