0.96Inch RGB OLED Display Module, For Arduino / Raspberry P

Detailed Information About The Product:

0.96inch OLED Display Module, Embedded SSD1357 driver chip, SPI Communication
64x128 resolution OLED display, 65K colors, clear and colorful displaying effect
SPI interface, minimizes required IO pins
Comes with online development resources (examples for Raspberry Pi/Arduino/STM32)
Operating voltage: 3.3V/5V (Please ensure that the power supply voltage and logic voltage are consistent, otherwise it will not work properly)

Support interface: 4-wire SPI, 3-wire SPI
Controller: SSD1357
Resolution: 64 (RGB) x 128
Display color: 65K color
Display Dimension: 10.8624 (W) x 21.736 (H)mm
Pixel size: 0.0327 (W) x 0.146 (H)mm
Module size: ablut 32.5 x 26.0mm
Control Interface:
VCC --Power (3.3V / 5V input)
GND--Ground
DIN --SPI data input
CLK --SPI clock input
CS --Chip selection, low active
DC --Data/Command selection (high for data, low for command)
RST --Reset, low active
OLED and its controller:
The built-in driver used by this OLED is SSD1357, which is a 128RGB * 128 Dot Matrix OLED/PLED controller with a 128*128*18bit SRAM as a display buffer area, which supports two color depths of 262k and 65k. And supports 8bit 8080 parallel, 8bit 6800 parallel, 3wire-SPI and 4wire-SPI, and other communication methods
This module selects 4wire-SPI and 3wire-SPI as the communication method, which reduces the area of the module and saves the IO resources of the controller
Colour:blue
Material:Metal

Package Contents:
1x RGB OLED Module
1x 7Pin Cable

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.