Boyseen Anti-blue Myopia Glasses 6008

Brand: BoyseenProduct category: myopia glassesMaterial: PCStyle: full frameModel: 6008Degrees: 100 degrees 150 degrees 200 degrees 250 degrees 300 degrees 350 degrees 400 degrees 450 degrees 500 degrees 550 degrees 600 degreesStyle: unisexStyle: elegantItem: 6008 myopia glasses frameFrame color: bright black frame (blue film), black outside and red inside (blue film), black outside and blue inside (blue film)Whether cross-border export exclusive source of supply: NoLens color: 0 degrees, myopia -100 degrees, myopia -150 degrees, myopia -200 degrees, myopia -250 degrees, myopia -300 degrees, myopia -350 degrees, myopia -400 degrees, myopia -450 degrees, myopia -500 degrees , Myopia -550 degrees, myopia -600 degrees
Glasses care1. Use both hands when putting on or taking off the glasses: hold the frame leg gently, one-handed removal will break the left and right balance; and when wiping the lens, hold the middle beam of the frame with one hand (do not hold the mirror Leg), gently wipe with one hand, otherwise, the frame may be deformed or the screws loosened over time.2. Do not place the mirror face down when placing it: the mirror face should be placed up or up, if it is placed down, it will wear the most important lens center.3. Fold the frame from the left first: Most frames are designed to be folded from the left, so if you fold the right first, it will be more laborious and will cause the frame to deform.4. Be sure to use a special lens cloth or soft paper towel when wiping the lens: Never use a corner or hand towel to wipe the lens; when the lens is heavily stained or dusty, it is best to use a neutral detergent (such as detergent Etc.) Rinse with water, and then wipe gently with a lens cloth, otherwise the lens is likely to be worn.5. Sweat and oil stains on the frame and nose pads can be wiped with a dry cloth or paper towel: Dirt that is difficult to remove can be wiped with a little soap and water, or ultrasonic cleaning at the optician.6. Try to avoid contact with water vapor, oil fume, sweat, and some cosmetics, etc .: These substances have a strong corrosive effect, which will cause certain damage to the film layer of the lens and the plating of the frame. In order to prolong the service life of the glasses, they should be isolated.7. Do not stay in high and low temperature environment for a long time: Do not put the glasses on the control panel of a car exposed to sunlight or bathe with glasses to avoid the distortion and deformation of the glasses as a whole; when the outdoor activities are particularly cold, pay attention to prevent the plate frames from being brittle or cracked. Lenses fall off.8. After wearing the glasses, always check whether the screws are loose: if they are loose, tighten them in time (preferably go to the glasses store) to prevent the lenses from falling off or missing parts.