DC10-32V To DC12-60V Voltage Step Up Converter Boost Po

Features:

• 
  
  This is a non-isolated DC power converter module with long service life.
  
  
• 
  
  High power and stable output, it converts 10-32VDC to 12-60VDC.
  
  
• 
  
  High quality components ensures high conversion efficiency, up to 95%.
  
  
• 
  
  Designed with large heat sinks for better heat dissipation.
  
  
• 
  
  Widely use for solar power voltage stabilization charging, battery pack charging, large power LED driving, etc.
  
  
  

Specification:

Type: Non-isolated step up module (BOOST)

Input Voltage: 10~32VDC

Input Current: 16A (MAX.); if more than 8A, please enhance heat dissipation

Quiescent Current: 15mA(tested when converting 12V  to 20V; it will increase when output voltage is higher)


Output Voltage: 10~60VDC continuously adjustable


(Applies only to where the input voltage is less than the output voltage, can not step down voltage)


Output Current: 8A (related to the input and output voltage difference, the greater voltage difference is, the smaller output current will be. please enhance heat dissipation when current is over 4A)


Constant Current Output Range: 0.3~8A


Turn Lights Adjusting Range: 0.3~8A


Output Power: Natural cooling 90WMAX; Enhanced cooling 150WMAX


Operating Temperature: -40℃ to 85℃(if temperature is too high, please enhance heat dissipation)


Frequency: 150KHz


Conversion Efficiency: 95% (Efficiency is related to input/output voltage, current and voltage difference)


Short Circuit Protection: Yes (input 15A fuse)


Reverse Input Protection: No, usually can connect diode in series to the input


Output Indicator Light: With charging indication; it shows red when charging, green when fully charged


Output Flow Back Protection: Yes


Installation Method: Four 3mm screws (NOT included)


Wiring Method: Terminal blocks


Weight: 74g / 2.6oz (approx.)

Package list:

1 * Voltage Converter

Current Adjustment:


1, Adjust the CV potentiometer, depending on the

load requirements, adjust the output voltage to the appropriate value,

example:4 series of battery to 55V, 10 series LED to 37V


2, The

module output current value is set to minimum (rotate counterclockwise

CC potentiometer till you hear small crack sound from the potentiometer)


3,

Connect to ammeter, connected to the LED or battery, adjust the CC

potentiometer to the required current. If used for charging, discharge

battery before adjustment.


Because the more battery power, the

smaller charging current. Note that current of this module cannot be

adjusted with short circuit.


4, Turn light current adjustment, used

to indicate whether the battery is fully charged.Red light is on when

charging, green light is on when fully charged. Connect a fully charged

battery to output end, and adjust turn light potentiometer till green

light is on.