This high quality hair clipper is suitable for home use and for professional salon use. Here are some of the features:Model: NG-101 Power: 10W.  6,500 RPM; Can be zero lappedSuper sharp and low noise. 2,000 mAh lithium battery.Battery capacity LED display.Cord and cordless use (AC & DC). Durable high tech permanent magnet motor, won't get hot during use.Over charge and over discharge protection.Voltage requirement: 100-240V 50/60 Hz.Accessories: 4 guide combs (3, 6, 10, 13 mm), adapter, cleaning brush, clipper oil. How to UseCharge the clipper fully before first use.Set the On/Off switch to Off while charging. FULL will be displayed on the LED screen after fully charged.To attach a guide comb, slide it onto the cutting head until it clicks into position. The clipper must be switched off while the guide comb is being attached or removed.

CAUTIONBlades on new clipper are very sharp and can cause injury if not properly adjusted and handled with care. Be extremely careful especially when using clipper to shave facial hair. 

HELPFUL NOTICEBattery capacity LED display may not correctly display remaining battery capacity. Please recharge clipper when clipper vibration becomes low, regardless of battery capacity being displayed.    

Wmark PROFESSIONAL CORDLESS HAIR CLIPPER (NG-101)

This high quality hair clipper is suitable for home use and for professional salon use.

• Model: NG-101
• Power: 10W
• High precision carbon steel blades;  6,500 RPM; Can be zero lapped
• Super sharp and low noise.
• 2,000 mAh lithium battery.
• Battery capacity LED display.
• Cord and cordless use (AC & DC).
• Durable high tech permanent magnet motor, won't get hot during use.
• Over charge and over discharge protection.
• Voltage requirement: 100-240V 50/60 Hz.
• Accessories: 4 guide combs (3, 6, 10, 13 mm), adapter, cleaning brush, clipper oil.
• 
  

How to Use

• Charge the clipper fully before first use.
• Set the On/Off switch to Off while charging. FULL will be displayed on the LED screen after fully charged.
• To attach a guide comb, slide it onto the cutting head until it clicks into position. The clipper must be switched off while the guide comb is being attached or removed.