Mercury 650va Maverick Line Interactive UPS

Line Interactive Mercury UPS 650 topology includes technology that enables the UPS to interact with incoming AC voltage and correct minor voltage fluctuations without switching to battery. 

This extends the life of the battery and is essential in areas where frequent power fluctuations are common. 

The Mercury UPS 650VA Maverick line interactive is ideal for Personal Computers and Electrical Equipment. 

Protects from damage, downtime, and data loss.

Technical Specifications

 Input voltage 220VAC

Input frequency 50Hz

Input phase Single phase

Input socket With Fuse

Cold Start (0 to 100% load) Press the ON/OFF switch

Input range (220V) 140V-300V

Rating output (VA). 650VA

Rating output (W). 390W

Rating output (W). Battery mode(simulated sine wave),

AC mode (sine wave)

Power factor 0.6

Rating voltage 220V

Output range 220Vac-7%+15% ( in battery mode )

Rear Output Socket 2xUniversal - Battery backup

Transfer time TYPICAL 4-8 ms

Communication Interface NIL

Rating frequency 50Hz

Output Frequency Line-mode Synchronize with the Utility

Battery mode 50 Hz±1Hz

Output Frequency Line Mode Synchronize with the utility

Short Circuit Protection Line Mode FUSE & firmware protection

Battery Mode Software protection controlled by firmware

Overload Protection Line Mode 110%+-5% (Go to fault mode after 5 minutes)

120%+-5% (Go to fault mode immediately)

Battery Mode 110%+-5% (Shutdown after 5 minutes)

120%+-5% (Shut down immediately)

Rating frequency 12V/8.2AH 1x Backup Time - Typical 10mins to 18mins
(depending on load)

Charge Current About 1A at normal mode

Over Charge Protection >14.5V +/- 0.2V stop charging

Weight 5.6kg +/- 0.3Kg

Dimension 390x 145 x 220 (mm)