Home Electronics Accessories & Supplies Camera Accessories Camera Grips & StrapsThermal Conductive Paste

Share this product

Thermal Conductive Paste

₦ 5,000

3 units left

+ shipping from ₦ 1,000 to LEKKI-AJAH (SANGOTEDO)

0 out of 5

(No ratings available)

Promotions

Call 02018883300 To Place Your Order Enjoy cheaper shipping fees when you select a PickUp Station at checkout.

Report incorrect product information

Delivery & Returns

Choose your location

Pickup Station

Delivery Fees ₦ 1,000

Ready for pickup between 11 September and 14 September if you place your order within the next 1hrs 3mins

Door Delivery

Delivery Fees ₦ 1,600

Ready for delivery between 11 September and 14 September if you place your order within the next 1hrs 3mins

Return Policy

Free return within 7 days for ALL eligible itemsDetails

Seller Information

AOT Electronics

78%Seller Score

3 Followers

Seller Performance

Shipping speed: Good

Quality Score: Excellent

Customer Rating: Very Poor

Cancellation Rate: Excellent

Product details

Thermal conductive paste (also called thermal grease, compound, or TIM) is a viscous material applied between a heat source (like a CPU or GPU) and a cooling device (like a heat sink or liquid cooler). Its primary purpose is to eliminate microscopic air pockets caused by surface imperfections, ensuring efficient heat transfer to prevent components from overheating.

Features:

High stability & reliability
Apply to : CPU, VGA, LED, Chipset and other PC components
Packing: syringe
Easy operation
Helps effectively dissipate heat from processor to radiator
Suitable for: radiator, processor or chips
Low thermal resistance, high conductivity , high temperature resistance
Non-toxic, tasteless, not aggressive
Compliance with RoHS REACH PFOS requirements
Net weight: 30g
Grey thermal paste
Thermal conductivity: greater than 1.90 W /m-k
Thermal resistance : less than 0.225C - in/w

Specifications

Key Features

Step 1: Prep & Clean the Surfaces

You must completely remove all old, crusty residue before applying new compound.

Dampen a microfiber cloth or coffee filter with 90%+ Isopropyl Alcohol (rubbing alcohol). Do not use paper towels, as they leave behind lint.
Wipe down the processor surface gently until the metal shine returns.
Wipe the baseplate of the cooler where it contacts the chip.
Let it dry completely for 1–2 minutes.

Step 2: Choose Your Pattern

Pick one of these standard configurations based on your processor type:

The Single Pea (Best for Standard CPUs): Squeeze a tiny dot (4–5mm wide, about the size of a pea) directly in the dead center of the chip. The weight of the cooler will squeeze it outward naturally.
The "X" Shape (Best for Large or Square CPUs): Draw a thin "X" from corner to corner. This delivers excellent coverage to the corners of larger square desktop processors.
The Butter Spread (Best for Direct-Die GPUs & Laptops): Use a plastic spatula or a gloved finger to spread an ultra-thin, smooth layer across the entire surface. This is mandatory for bare graphics card chips, as they have no built-in metal cover to protect them.

Step 3: Mount the Cooler Immediately

Once the paste is down, drop the heatsink or water block straight down onto the CPU.

Avoid twisting or sliding the cooler around once it touches the paste, as this introduces trapped air bubbles.
Tighten the screws in a crisscross pattern (e.g., top-left, bottom-right, top-right, bottom-left). Turn each screw a few times to slowly pull the cooler down evenly, ensuring the paste spreads uniformly.