No Controller Silicone for Creality CR 10 S5 3D Printer Adhesive

Size:8x8MM

Dual wattage for heating zone(Inner zone 200x200mm is 200w,out zone is 1300w)

Voltage:100-240V avaliable

3M PSA

NTC 100K Thermistor and digital temperature controllor

* With independent temperature controller .need plug with independent power * Size: 510-510mm suit for CR-10S5.*Power consumption :Maximum power 1300W*The maximum heating temperature 120C（Celsius Degree）

*Heat the build bed to 100°C within 10 minutes,maximum heating to 120°C

*thermistor value of digital controller :B4537 1K, if you need connect to your own mainboard(Not recommend), need use 39 100K* The back with 3M adhesive , can directly stick to the heated bed. need disaemble the S5 bed before aemble it* The heated pad Maximum temperature resistant is 200C, long term working temperature condition is under 180C* This is 28 hole version, beyond 24 postion hole, extra 4 hole is for cooling* To ensure safety , the plugs are 3 pins*When use, please do some test to find a suitable temperature for you touse, for example, when heating pad working , if you want heat the bedto 100C, please set the silicon to 75-80C, no need to set to100C, for the printer its can heat too. this can save electricitycost and envment friendly1:Please find aemble ts in Youtube by searching "CR-10S5 silicon heating pad"2. This Heating pad Voltage is 110V, suit for US,CA or JP to use, if you need 220V, need contact us to sh from China factory.3.ant!When turn off the heating pad, please pre the botton at least 5second, make suse the red indicator light in the screen is off, if just ashort pre on the on, will only turn off the screen, but theheating wilo on