MAXKGO BMS Li-Ion Battery 4S 5S 6S 7S 8S 10S 12S 13S 14S 12V-24V 200A Pack Balance Protection Board for 18650 Battery,4-7S

Product Description: Charging current: less than equal 60A; Discharge current: 200A; Internal resistance: less than equal 15m ohm; Charging voltage:The number of Li-ion batteryin series connection X 4.2V; Wiring : Same Port
Overcharge protection: Detection voltage: 4.25±0.025V; Detection delay: 1000±500MS; Release voltage: 4.15±0.05V; Over-discharge voltage protection: Detection voltage: 2.75±0.1V; Detection delay: 1000±500MS; Release voltage: 3.0±0.1V
Balanced voltage: Detection voltage: 4.15±0.025V; Detection delay: 100±50MS; Balance current: 42±5MA; Over discharge current protection: Detection voltage: 50±15MV; Detection delay: 1000±500MS; Current protection: 600±60A
Short circuit protection: Trigger condition: external short circuit; Detection delay: 300us; Release condition: disconnect the load; Temperature control protection: Charge and discharge over-temperature protection: 55℃; Charge and discharge high temperature release temperature: 75℃; Release condition:During normal working temperature
Self-consumption: Working power consumption: less than 35UA; Over-discharge power consumption(Sleeping State): less than 10UA; Operating temperature range: -30°~+80°C; Product Features: Overcharge protection; Over discharge protection; Overcurrent protection; Balanced protection; Temperature control protection

ATTENTION:
1. The sequence of connecting wires for BMS:
a. From thin black balance wire to stare, the 2ndwire(thin red wire)connect with the 1stbattery's positive pole.Then connect each cell's positive pole in order until the last one B+.
b.Please do not insert the plug directly after the cable is connected.Measure the voltage between each two adjacent metal terminals on the back of the plug. If it is a ternary polymer battery, the voltage should be between 3.0 ~4.2V, and the voltage of the iron-lithium battery should be between 2.0 ~3.6V. The voltage should be between 1.5~2.75V.
c.After confirming that the wiring sequence and voltage of the cables are correct, insert them into the socket of the protection board.
Attentionplease: The cables of different manufacturers are not universal, please make sure to use the matching cables.
2. After the wiring is completed, measure whether the voltage of battery B+and B- ,andthe voltage of B-and C- are equal. If they are equal, the protection board is working normally and can be used normally. If it is not equal, please check the wiring again.
Type:4-7S
color:Green
Material:composite material

Package Contents:
1 x PCBA board
1 x HY2.0 single head 8P line

Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.