Key Card Power Saver Switch

1. Name

Hotel Key Card Power Switch (also known as a Hotel Energy Saver Switch, Key card Wall Switch, or Insert Card for Power Switch).

2. Description

This device is a wall-mounted electrical switch designed to control power in hotel guest rooms or serviced apartments. It consists of a durable metallic faceplate with a card slot printed with the text "INSERT KEY FOR POWER" and a direction arrow. When a key card (or standard plastic card/RFID card depending on the switch type) is inserted into the slot, it triggers an internal relay mechanism that energizes the room's primary electrical circuit (lighting, power sockets, standard electronics).

3. Features

Metallic Finish: Standard square faceplate with softly rounded corners and a brushed/satin metallic surface (often silver, brushed steel, or nickel).

Card Slot Holder: Front horizontal retaining bar with standard directional guidance arrows and bold block typography.

Energy-Saving Delay Relay: Built-in timer circuit that maintains power for 15 to 30 seconds after card removal.

High Load Capacity: Rated for standard mains voltages (110V–240V AC) with high amperage support (typically 16A–40A) to safely handle lighting and power circuits.

Standard Wall Box Mounting: Designed to fit standard 86mm × 86mm back boxes or Euro-module mounting frames.

4. Highlights

Energy Efficiency & Cost Reduction: Cuts phantom electricity loads and turns off non-essential appliances/lighting when guests exit, reducing hotel power consumption by up to 30–50%.

Safety Enhancement: Reduces risks of overheating or electrical fires caused by forgotten high-power appliances (e.g., irons, hair dryers) left running when the room is unoccupied.

Delayed Shutdown: The delayed turn-off function ensures guests can safely exit the room in illuminated conditions before the power turns off completely.

5. Instructions for Use

Operating Instructions

To Turn On Power: Upon entering the room, slide the key card downwards into the card slot following the arrow guide. The switch will click/engage, restoring power to the room.

To Turn Off Power: When exiting, pull the key card straight up out of the slot. Room power will remain active for approximately 15 to 30 seconds to allow exit before shutting down automatically.

Installation Instructions (Qualified Electricians Only)

Safety First: Always disconnect the main electrical supply at the circuit breaker panel before handling.

Wiring:

Connect the incoming live wire to terminal L (Line In).

Connect the load wire (going to room lights/sockets) to terminal L1 / NO (Normally Open / Output).

Connect the neutral wire to terminal N (if required by model).

Mounting: Secure the back plate into the wall box using the provided screws and snap on the faceplate.

6. Maintenance

Regular Cleaning: Wipe the exterior surface periodically with a clean, dry, or slightly damp microfiber cloth. Do not use liquid sprays directly into the card slot or abrasive harsh chemicals.

Dust Removal: Use compressed air occasionally to blow out dust or lint that may accumulate inside the card slot.

Inspect Slot Mechanical Switch/Sensors: Ensure card insertion remains smooth without jamming or physical obstruction.

Terminal Checks: During periodic routine hotel electrical inspections, verify that wiring terminal screws behind the plate remain tight.