Bias Binder Bias Binding Presser Foot

The foot is fitted with two grooves that folds the bias tape in bias form. It is also fitted with main fabric channel that allows you feed the main fabric edge into the foot while attaching the bias into the edge of the fabric.
It is used to apply pre-folded bias binding tape or bias tape you have cut yourself to the edge of fabric in one easy step.It is equipped with a small funnel to fold and guide the binding over the fabric edge before it reaches the needle and can be used with either zigzag or decorative stitches as well as straight stitch.
10 mm to 14 mm bias tape can be used.
Fit for All Low Shank Singer, Brother, Babylock, Viking (Husky Series), Euro-Pro, Janome, Kenmore, White, Juki, Bernina (Bernette Series), New Home, Necchi, Elna,etc.

Use Instructions:
1. Before installing the presser foot, turn the trim strip inserted into the guide groove of the presser foot, trim selvage ensure alignment of the presser foot guide groove;
2. Pull the trim strip from the rear of the presser foot;
3. Install the presser foot;
4. Adjust the needle position, until the needle point is located at the edge trim.
Tip: If you can not adjust the needle to the appropriate location on the trim, you can loosen the presser foot screw and move around to adjust the position of the guide groove.