Baseus Emergency Car Jump Starter Power Bank - 10000mAh

Baseus Car Jump StartHow to use the 70mai jump starter? With the device as a 12 V jump starter:
1. connect the jump starter to the device. Make sure the indicator on the battery clips are gone.

2. Connect the battery clips properly around the positive and negative ends of the car battery. The red clip should be the
positive (+) end, while the black clip should end with the negative (-). Then, follow the instructions below:

When the green light is turned on, the connection is correct and the battery can jump started.

When the red light is turned on and a buzzer sound can be heard, the clips are connected to the wrong ends. Connect the clips
correctly and make sure the green light is turned on before jump start the battery.

If the green light is flickering and a buzzer sound can be heard, the voltage is too low. Press the boost button and wait for the
green light to stop flickering. Jump-start the battery within 30 seconds.

If both the green and red lights are not turned on and no buzzer sound can be heard, the battery may be damaged. Make sure the
clips are connected to the right ends. Press the boost button and wait until the green light is turned on. Jump-start the battery
within 30 seconds

3. After the car is jump started, remove the battery clips