Dp LED Rechargeable Flashlight Zoom effect Torch - Long & Wide range

• Uses 1 high-power LED + COB light beads
• Pressing the switch allows for selection of flashlight high beam, low beam, strobe, and emergency light functions
• Low battery level prompt function
• Low voltage protection function
• LED beam focus can be adjusted by extending or retracting the head of the flashlight 

Instructions for Use:

• When charging, connect the charging cable to the 5V charging port of the charger and the light. The red light flashing indicates that it is in charging status, and the light stays on when fully charged, taking about 3-4 hours for a full charge.
• When the battery voltage is below 3.2V, the indicator light will flash once every 4 seconds. When it is below 2.6V, the flashlight will automatically shut down. Press and hold any mode for 2 seconds to turn off.
• Pressing the switch allows for selection of flashlight high beam, low beam, strobe, and emergency light functions.
• When fully charged, the flashlight has a battery life of approximately 3-7 hours. The emergency light has a battery life of approximately 6-7 hours.
• During use, if the LED light becomes dim, indicating the battery is close to fully discharged, stop using it and promptly recharge it to protect the battery.
  Do not wait until the LED light is completely off before charging, as this can easily damage the battery)
• The flashlight should be regularly recharged and used, and not left idle for long periods. If not used frequently, recharge it at least once every three months to avoid reducing the battery's lifespan.

Safety Precautions:

• Do not expose the product to rain or moisture, and do not shine the light directly into the eyes to avoid affecting vision. (Children should use it under adult supervision)
• Keep away from flammable and xplosive materials during each charging session, and the charging time should not exceed 8 hours. it is recommended to charge during the day)
• Non-professionals should not attempt to repair the product. If the light malfunctions or maintenance is needed, disconnect the power source to prevent electric shock.
• To prevent accidents such as the light falling and causing damage, electric shock, fire, etc., strictly follow the instructions for installation and use. Do not modify the flashlight or swap components on your own.
• The light source is not replaceable; when the light source reaches the end of its life, replace the entire lamp.
• Do not use the product while charging to avoid damaging the LED light or internal charging components.
• Do not use non-rechargeable batteries.
• If a battery leaks, stop using it immediately and dispose of it properly; do not dispose of batteries casually. Before disposing of the device, remove the batteries from the battery compartment. When removing the batteries, ensure the device is powered off to prevent accidents. Dispose of the removed batteries properly or hand them over to specialized recycling facilities for disposal.
• If the power cord is damaged, it must be replaced with a specialized cord or component obtained from the manufacturer or repair department.