For Toyota Car Reset Device To Relieve Tire Pressure Cycle

For Toyota Car Reset Device To Relieve Tire Pressure Cycle

1. Voltage: 12V
2. The TPM50 is to be used with a properly formatted TPMS scanning tool
3. System on TPMS system is locked in loop mode: If your TPMS tool gives you the error message "Cannot write ID to control module" when performing the 4. TPMS relearn procedure, then the vehicle's TPMS system is stuck " cycle mode"
5. What causes the TPMS system to go into "loop mode" on a vehicle: If after replacing the TPMS sensor, before programming the new sensor into the control module via the TPMS scan tool, the TPMS reset switch is pressed (in TPMS equipped cars ), the vehicle may get stuck in a loop
6. TPM50 is suitable for Toyota TPMS circuit reset: vehicles with TPMS warning light stuck in the "ON" position
7. Missing or damaged sensors or blank sensors installed but not yet programmed, which will cause the vehicle to get stuck in a loop
8. Plug in the OBDII connection and hold the button to reset, TPMS reset tool does not require pin jumps
9. Quickly reset the TPMS light and continue TPMS maintenance
10. Note: This TPMS reset tool is only suitable for TPMS LOOP mode, not for TPMS relearning or TPMS sensor programming
11. Dimensions: 23x45x59mm