7 810.1 12.1 13.3 15.6 capacitive touch screen G+G structure USB plug and play 10 point touch

precautions for use

When using the touch screen, please note the following:1 as the capacitive touch screen is made of gla, do not strike forcefully or fall from a height.2 do not put the capacitive touch screen from the FPC position.3 do not overlap or pre with heavy objects during storage.4 do not directly contact the parts on the touch screen FPC with conductive materials such as metal, to avoid short circuit and other electrical propertiesA good.5 do not repeatedly bend or forcefully pull the FPC during installation to avoid folding injury; Avoid dead folds of 90 and 180 degrees (which can cause FPC wires)Road fracture, resulting in poor product function).6 do not touch the ink behind the capacitive touch screen with hard objects during installation to avoid scratches.7 do not touch the visible area during installation. If touching causes dirt, please use the cleaning method specified by wentai touch to remove the dirt.8 when operating capacitive touch screen, please use finger or conductive pen to touch.9 pay attention to high voltage and ESD protection.10 it is suested that the customer tear off the protective film of the finished product before use, carry out neceary cleaning proce and appearance, and then carry out subsequent proceing and aembly workThe product protective film that has been torn off is d back to the product, because the protective film that has been torn off has been contacted by the operator inside the protective film, causing pollution, and then the product that has been torn offProtective film affixed back to the product will certainly cause contamination transfer pollution11 customers or users are strongly ased to completely tear off the protective film before using the product for appearance or lamination, and then use the dustfree room for special purposeThe dust-free dry cloth plus an appropriate amount of cleaning soent, wear clean , and then use good cleaning techniques for cleaning, ar effective product surface cleaning, howeverAr the appearance , the appearance must ensure that the product can not have.12 it is strongly recommended that customers or users should completely tear off the protective film before using the product for appearance or lamination, and then use the dustfree room for special purposeThen wear clean to clean the dry dust-free cloth plus an appropriate amount of cleaning soent (such as A or Ethanol), and perform cleaning by good cleaning methods ar effective productionAr the surface is cleaned, an appearance shall be conducted. Ar the appearance , it is neceary to ensure that there is no additional dirt or dust or fingerprint on the productThen it can be fitted and aembled.

Product structure diagram