64 LED Bicycle Bike Rear Tail Laser Indicator Turn Signal Light Wireless Remote

Feature:
1.The dot matrix display, the cool graphics tail light display, the brake dot matrix display, and the laser parallel lines display of this wireless remote control turn light.
2.With Rechargeable Lithium battery, 3.7V 650mAh, can work up to 10 hours continuously after one time charge.
3.One CR2032 battery for remote control, which can work up to Three months.
4.One CR1225 battery for the brake launcher, which can work up to Six months.
Specification:
Type:Rear Light
Brand:Unbranded
Bulp Type:LED
No. of LEDs:64
Waterproof:Water Resistant
Material: ABS
Laser Beam: 2

Operation Instruction:
1.Long press host one second to switch on(all the lights flash three times), and long press host one second again to switch off(all the lights flash one time). The left red light is flashing after switch on, long press 3 seconds to Match Code( host showed C), then press the any key of the remote controller to finish the setting.
2. upward the turn light-switch to Left( the left light is flashing), downward the turn light-switch to Right(the right light is flashing).
3. Short press the right button of remote control, cool graphics tail light will switch on/off (blue light flash in the middle).
4. Short press the left button of remote control, laser parallel line will switch on/off.
5. All the lights of host will lighten on when brake the bicycle.
6. When the left light of host is continuous lighting, it means the low batter and need to recharge. The right light will turn on when recharging the battery, and the green light will turn on when fully charged.