915 Generation 4S 40A Active Enhanced Balancer 18650 Lithium Battery

Detailed Information About The Product:

1. 4 series 16.8V 40A lithium battery protection board (with its own recovery function - AUTO Recovery)
2. Integrate 10 imported low-resistance MOS tubes with a continuous discharge of 40A, suitable for electric drills, sprayers, LED lights, and low-power inverters
3. Scope of application: Applicable to 4.2V lithium battery with nominal voltage of 3.7V and full voltage. It is suitable for electric drills with starting current below 80A and power below 230W.
4. The high current heating is reduced by 30%, and the anti-interference function is increased
5. Product weight: 9.3g; Charging voltage: 16.8~18.1v; Continuous discharge current (upper limit): 40A (if the heat dissipation environment is not good, please reduce the load current); Continuous charging current (upper limit): 20A

Conditions for successfully starting the electric brick:
1. 4 15C-20C power batteries or 810C-15C power batteries (ordinary 18650 power drills are required!)
2. The connection line between the battery pack and the protection board should be as short as possible and as thick as possible
3. When welding the battery for the first time, do not need any load or any equipment at the output end.
Precautions:
1: 4 10C-20C power batteries, or 8 5C-10C power batteries are required to successfully start the electric drill (recommended power battery models: SONY VTC4, VTC4A, VTC5A, VTC6) 0V and 12.6V connecting cables, use 3 square mm above copper wire (nickel sheet cannot be used!!)
2: Strictly connect 0V, 4.2V, 8.4V, 12.6V, 16.8V according to the diagram, do not touch any components on the board when soldering the wires, and do not intentionally short-circuit.
3: When the battery is welded for the first time or is being charged, as long as a single battery exceeds the 4.2V430 resistance, it will heat up and discharge (discharge to about 4.19V and stop heating). If the 430 resistor is seriously hot (don't dare to touch it when it is too hot), please check whether the wiring is wrong
color:Green
Material:PCB
size:45 x 55 x 3.4mm

Package Contents:
1 x 4 increase board

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.

About Us
We provide the good product with the best price,we support Wholesale/Drop Shipping Order
1. For Drop Shipping order, please remark"dropshipping order", we will prioritize it.
2. For Wholesale/Drop Shipping orders, if you have any ideas about the price or package,please contact us in advance,we will give you the best service to satisfy your demands.

About Shipments
1.We will send out the orders ASAP once your payment is completed normally.
2.Please write your complete delivery address with correct phone number and zip code, especially please confirm your full name.

About After-sale Service
We are reliable seller and we have our professional after-sale service for all of our customs. If there is any question about the order,please contact us in advance ,we will always here until you get a happy answer.

About Feedback
1. Please check the package and item when you get carefully to make sure there is no problem.
2. If you have any problem or are not entirely satisfied with your package,please don’t be hesitate to contact us first before leaving negative feedback. We will resolve the problem to satisfy you.
3. If there is no problem, please leave us five star positive feedback.
Your affirmation is our greatest motivation ! !